Trailer Jack? Drill It. 😄🔩

Honestly, there are few things more annoying than manually cranking a trailer jack when you’re trying to get in, hook up, and get moving.
This Trailer Jack Drill Adapter (1 inch) is basically the “fine, I’ll do it the smarter way” upgrade for the right jack setup.

Check Availability on Amazon

What it does (and the important “only if” parts)

1-inch drive shaft

The biggest appeal is that it lets you use a standard cordless drill to raise and lower a trailer jack—without needing an impact driver.
It’s designed to fit 1 inch drive shafts only, and the listing also notes it does not work for gooseneck trailers.

It uses a low-speed range that’s a good match for a typical drill/driver setup (the adapter is intended for low-speed, high-torque use).
So at some point, when you’re tired of the crank, you can swap “manual effort” for “press-and-go control.”

Product explanation

Ready-to-install kit

This is a complete adapter kit. It includes the adapter plus the small hardware you need to install it on the jack drive shaft:
a clevis pin and two R-type hairpin cotter pins. That means you can usually get it mounted right away instead of hunting for parts.

It’s also built with a 1/2-inch square drive socket, so you can use it with either a power drill or a standard 1/2-inch ratchet setup,
depending on what you’ve got on hand.

Quick safety tip from the listing: use with a low-speed, high-torque drill, avoid impact drivers, and stop before full extension.

Key Features

Perfect fit for 1 inch drive shafts only (not compatible with gooseneck trailers, per the listing)
Drill use intended: designed to work with a standard drill/driver, not an impact driver
Dual-drive versatility: includes a built-in 1/2-inch square drive socket for drill or 1/2-inch ratchet use
Heavy-duty, rust-resistant construction made from upgraded stainless steel for outdoor conditions
Complete kit included: adapter, clevis pin, and two R-type hairpin cotter pins
Wide trailer use mentioned for RV, construction, and dump trailers (as long as the jack drive shaft matches)

Why This Product Exists

Less cranking

This adapter exists for the people who’ve ever thought, “There has to be a better way than wrestling that jack handle.”
It’s basically designed for situations where you want controlled raising/lowering with a drill,
while still keeping the connection secure and straightforward for DIY trailer tasks.

The biggest “real life” win is time and effort—especially when you’re doing the same setup steps more often than you’d like.

Best Fit For

Check your jack

This is a good match for:

Trailers where the jack has a 1 inch drive shaft
DIY enthusiasts who already use a cordless drill for other tasks
People who prefer low-speed, high-torque control over manual cranking
Work setups involving RV, construction, or dump trailers (when compatible)

This may not be the right choice for:

Gooseneck trailers (not compatible per the listing)
Anyone planning to use an impact driver (the listing specifically says drill only)
Setups where the jack drive shaft is not 1 inch

If you’re unsure, the simplest move is to confirm your jack drive shaft size first—compatibility is the whole game here.

Final Verdict

A practical adapter

If your trailer jack uses a 1 inch drive shaft, this adapter is a handy way to turn a cordless drill into controlled jack operation.
The kit is straightforward, the stainless steel build is meant for outdoor use, and the “drill only / low-speed” guidance helps keep things sensible.

Just don’t try to force it onto the wrong jack type—especially gooseneck trailers—and you’ll be in the safe, intended lane.